Connect with us

factory settings pdp 433 pioneer plasma

Discussion in 'Troubleshooting and Repair' started by letmein, Dec 22, 2009.

Scroll to continue with content
  1. letmein

    letmein

    2
    0
    Dec 22, 2009
    Service manual of my pioneer 433 plasma
    http://rapidshare.com/files/324291996/pdp-433pu.pdf.html

    Hi, i have 433pg plasma pioneer, i've replaced the power supply the problem is. When i switch the power on the receiver the red light on the plasma is blinking fast. When the reciever is switched off the plasma's red light blinks slowly, In the service manual on the page 85 it says you need to press menu enter then power on thr remote control unit in that order to set it up and that the unit restarts and enters the factory mode, that's where the problem is it wont go to factory mode i've tried every thing and nothing comes on the screen all there is is the red light blinking. Would you have idea that you could give me so that i can get it started.
    your help will be muchly appreciated.
     
  2. letmein

    letmein

    2
    0
    Dec 22, 2009
    i think i should do factory setting reset because of trap switch can i do dat
    with the rs232 cable with (hyperterminal) because there is nothing on screen
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-