Connect with us

Extending wire leads on Flux gate sensor

Discussion in 'Boat Electronics' started by Steve, Feb 23, 2004.

Scroll to continue with content
  1. Steve

    Steve Guest

    I'm installing a Autohelm auto pilot which has a remotely located. The
    recommendation is a location that is low and near the center of motion.
    However, the cable lead is only 25ft long. That's about 15ft short of what I
    will need to reach the ideal area (mid ship).

    Since the cable run is inside, I don't have any problem doing a splice and
    seal of the cable. I'm just concerned if there might be some degradation of
    the signal from the flux sensor..

    I'm think, "not a problem" but I would appreciate comments on this..

    Steve
    s/v Good Intentions
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-