Connect with us

Export layout netilst by Mentor Calibre PEX

Discussion in 'Electronic Basics' started by boki, Sep 18, 2003.

Scroll to continue with content
  1. boki

    boki Guest

    Dear All:

    When I export layout netilst by Mentor Calibre PEX, the netilst file
    will convert all nodes as simple number even is power node or
    input/output node and convert a not completed subckt node for user.

    My situation:
    I have input/output node/pin in my layout, and I can get match on LVS
    check. But the layout netlist report didn't contain those input/output
    nodes again, just export them as simple number.

    For example:

    Schematic netlist:

    ..SUBCKT BOKI INPUT OUTPUT
    M1 OUTPUT INPUT VSS VSS NCH W=1u L=1u
    M2 OUTPUT INPUT VDD VDD PCH W=1u L=1u
    ..ends

    Layout export netlist:
    ..SUBCKT BOKI
    M1 1 2 3 3 NCH W=1u L=1u
    M2 1 2 4 4 PCH W=1u L=1u
    ..ends

    The problem is no input/output/power nodes on layout export netlist,
    and there is not a completed subckt for user.

    Could you please tell me how to fix it? or any setup method?

    Thanks a lot!
    Best regards,
    Boki.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-