Maker Pro
Maker Pro

Ethernet and mechanical relays

B

Bru

Jan 1, 1970
0
I'm looking for a relay able to switch a 100 MHz Ethernet line. I need it
because I have an ethernet switch chip (3 ports: IN, OUT, INTERNAL) on every
board (all are daisy chained), in case one board is turned off the daisy
chain line must not be interrupted and the relay without power (normally
closed) must short IN and OUT.
Any help will be very appreciated.
Ciao.
Bruno.
 
J

Jason

Jan 1, 1970
0
Bru said:
I'm looking for a relay able to switch a 100 MHz Ethernet line. I need it
because I have an ethernet switch chip (3 ports: IN, OUT, INTERNAL) on every
board (all are daisy chained), in case one board is turned off the daisy
chain line must not be interrupted and the relay without power (normally
closed) must short IN and OUT.
Any help will be very appreciated.
Ciao.
Bruno.

I have an Intel 1U chassis that had this setup and it just used plain
jane old mechanical relays. You need to throw 4 poles (1,2,3 and 6).
 
Top