Maker Pro
Maker Pro

Epson printer

G

Guy Sauvageau

Jan 1, 1970
0
Thanks ahead for your input
i have 2 Epson Stylus pro color printer
both show the same problem
often (15% of the time) it start printing in the middle of the page...
i can feel it when it is to do that cause the sound of the motor sqeek
but it is not lube it is more like a ac signal driving the stepping for a
sec.
what tell the printer to do that?
thanks ahead
Guy
 
J

Jerry G.

Jan 1, 1970
0
The print head assy and roller assy may require changing. It may be worn
or defective. If the printer is out of warranty, it will not pay to
service it, unless it is a very high end model. In any case, Epson will
not sell the parts or service information, you will have to bring them
the printer.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
==============================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
==============================================
Thanks ahead for your input
i have 2 Epson Stylus pro color printer
both show the same problem
often (15% of the time) it start printing in the middle of the page...
i can feel it when it is to do that cause the sound of the motor sqeek
but it is not lube it is more like a ac signal driving the stepping for
a
sec.
what tell the printer to do that?
thanks ahead
Guy
 
B

Brane

Jan 1, 1970
0
Jerry said:
The print head assy and roller assy may require changing. It may be worn
or defective. If the printer is out of warranty, it will not pay to
service it, unless it is a very high end model. In any case, Epson will
not sell the parts or service information, you will have to bring them
the printer.


I have three Epson 1200 Photos and one of them had similar problem.
With me, it was special bit of teflon that was inserted in plastic head
holder and was meant to slide over metal and give the head more or les
constant height over the paper.

That bit has fallen off its place, so whole holder was kinda hanging and
head assembly was dangerously low. Every now and then head has collided
with something else during printing and that caused effect that you
mention. Take a peek at the point where head holder slides over the metal
area...


I would snap a photo or two, but right now I'm in a middle of conversion
from Win2k to Gentoo Linux and I am lacking the tools at the moment....


Regards,


Branko
 
Top