Connect with us

Engineering Student in Need of Data

Discussion in 'General Electronics Discussion' started by bearsomg, Jan 3, 2013.

Scroll to continue with content
  1. bearsomg


    Jan 3, 2013
    I'm currently in an engineering senior design course, and our group is designing a cheaper, more efficient and available device for hobbyists to fabricate custom PCBs (printed circuit boards).

    We have a survey up here so we can figure out what is most important and help us decide what needs to be included in the design:

    You don't have to be an engineer to fill it out, so if anyone could fill this out it would be a great help.

  2. BobK


    Jan 5, 2010
    On your question about which methods you use, you should allow multiple selection. I have used most of those listed.

    Last edited: Jan 3, 2013
  3. Harald Kapp

    Harald Kapp Moderator Moderator

    Nov 17, 2011
    I second that.
    Specially when it comes to a distinction between homebrew PCBs and my job.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day