M
[email protected]
- Jan 1, 1970
- 0
Hello,
At the moment I am designing a new product with Protel DXP. The
schematic has 5 sheets. One top sheet and 4 schematics below this
sheet. I want to annotate the whole schematic, but I have a problem. I
want to group the same components (eg. C1 to C9 is 100NF, C10 to C13
is 27pF, C14 is 6N8, etc). The components are not grouped. I have
selected 'Comment' in the 'Match By Parameters' box. All the
checkboxes in the 'Schematic Sheets To Annotate' are selected. I don't
know what to do with 'Designator Index Control', so nothing has been
checked there and all number in 'Start Index'-fields are 1. All
'Suffix' fields are empty. What am I doing wrong?
Regards,
Mark
At the moment I am designing a new product with Protel DXP. The
schematic has 5 sheets. One top sheet and 4 schematics below this
sheet. I want to annotate the whole schematic, but I have a problem. I
want to group the same components (eg. C1 to C9 is 100NF, C10 to C13
is 27pF, C14 is 6N8, etc). The components are not grouped. I have
selected 'Comment' in the 'Match By Parameters' box. All the
checkboxes in the 'Schematic Sheets To Annotate' are selected. I don't
know what to do with 'Designator Index Control', so nothing has been
checked there and all number in 'Start Index'-fields are 1. All
'Suffix' fields are empty. What am I doing wrong?
Regards,
Mark