Maker Pro
Maker Pro

DVR shows no signal output

Quovadis

Jul 26, 2017
15
Joined
Jul 26, 2017
Messages
15
Hi all I have a DVR (H264 Network ) and I am getting the message no signal input ..... Normally it beeps when it restarts but nothing . Obviously tried the following, cables, monitor , use another monitor try the HDMI as an alternative ... use brand new cables , but the message is the same ... any ideas what the issue could be ? The unit powers up OK and the hard drive spins ok , and the power supply is Ok as I used it on another DVR ... but still no signal ?
 
Top