dsc siren

[CyberBear]

how to connect DCS siren with DSC control panel? When I connect on Bell+/-
keypad signal a trouble with siren

 

[Jim Rojas]

Try placing a 1,000 ohm resistor in parallel to the siren. DSC supervises
the bell output.

Jim Rojas

 

[CyberBear]

Try placing a 1,000 ohm resistor in parallel to the siren. DSC
supervises the bell output.

Jim Rojas

then siren go to alarm

 

[Jim Rojas]

Did you test the siren to see if it still works?

Jim Rojas

 

[julian]

Did you test the siren to see if it still works?

Jim Rojas

Do you have a siren or a speaker? Makes a big difference. Test the
siren on your battery if it is one. If it is a speaker don't test it
on the battery.


Julian.

 

[Bob La Londe]

Do you have a siren or a speaker? Makes a big difference. Test the
siren on your battery if it is one. If it is a speaker don't test it
on the battery.

Zzzzzt!


--
Bob La Londe

Cheapskate's Ways to Do Fishing Stuff
(The Frugal Fisherman)
Through the Month of October 2005

http://www.YumaBassMan.com

 

[Crash Gordon]

test it with a 9v radio battery...that won't ruin a speaker...a 12v 7amp
will though!


| On Mon, 17 Oct 2005 18:55:11 GMT, "Jim Rojas" <[email protected]>
| wrote:
|
| >Did you test the siren to see if it still works?
| >
| >Jim Rojas
| >
|
|
| Do you have a siren or a speaker? Makes a big difference. Test the
| siren on your battery if it is one. If it is a speaker don't test it
| on the battery.
|
|
| Julian.
|
|
| >| >> Jim Rojas wrote:
| >>> Try placing a 1,000 ohm resistor in parallel to the siren. DSC
| >>> supervises the bell output.
| >>>
| >>> Jim Rojas
| >>
| >>
| >> then siren go to alarm
| >>
| >>
| >
|
|

 

[CyberBear]

how to connect DCS siren with DSC control panel? When I connect on
Bell+/- keypad signal a trouble with siren

problem solved
panel:
Bell +/- resistor 1k
siren:
gnd-gnd
+N - +12Vfrom panel
A - PGM1 (panel)
and program pgm1 like alarm output

 

[Mark Leuck]

problem solved
panel:
Bell +/- resistor 1k
siren:
gnd-gnd
+N - +12Vfrom panel
A - PGM1 (panel)
and program pgm1 like alarm output

You COULD do that however now you are limiting yourself to available aux
power which is only 550 mA compared to 700mA from the Siren output.

You take the 1K and put it across the siren terminals which would then
connect to the siren output on the board not aux power