Maker Pro
Maker Pro

DSC Power 832 Software version

G

Guest

Jan 1, 1970
0
Is there a code that I can type in to see the software version of my board?

I am using an LCD5500Z keypad, and I think my board is a PC5010 Version 2.0.

Thanks
Michael
 
P

petem

Jan 1, 1970
0
you should try to do a autodetect of the panel by the dls 2002
software....it only failed once on me...

pretty good detection..
 
A

anomynous

Jan 1, 1970
0
Is there a code that I can type in to see the software version of my board?

I am using an LCD5500Z keypad, and I think my board is a PC5010 Version 2.0.

Thanks
Michael

I only know of 2 versions, you can tell but the spacing of the terminal
strip between where you connect up the zones and where you connect the
telco. Also, I believe that V1.0 don't have the header for pc-link.
 
M

Mark Leuck

Jan 1, 1970
0
Nope, only that it is a v2 is all that matters, if DSC did make
sub-revisions they never told anyone
 
M

Mark Leuck

Jan 1, 1970
0
anomynous said:
I only know of 2 versions, you can tell but the spacing of the terminal
strip between where you connect up the zones and where you connect the
telco. Also, I believe that V1.0 don't have the header for pc-link.

Correct, the v1.0 is also a larger board
 
Top