Maker Pro
Maker Pro

DSC Power 832 Programming

A

Armond Perretta

Jan 1, 1970
0
I noticed a few posts here that mentioned 700 series addresses in the 832
programming. However neither the instruction manual, nor the installation
guide, nor the programming worksheets, nor the DLS software for this panel
show any 700 series addresses. This made me curious enough to wonder what
these address are and how to find out more about them. Any help?
 
M

Mark Leuck

Jan 1, 1970
0
That was in the original 832 v1 but isn't in the v2
 
A

Armond Perretta

Jan 1, 1970
0
Mark said:
That was in the original 832 v1 but isn't in the v2

Well, that takes care of that. Thanks.

Meanwhile, is there any method to adjust the keypad clock (5500 LCD), which
seems to run a tad slow? The earlier posts on this seemed to concentrate on
issues related to 50 cycle versus 60 cycle setups.
 
M

Mark Leuck

Jan 1, 1970
0
No I wouldn't worry about the 50/60, in the v1 you had the option of using
internal crystal or AC line timing although with the v2 you are locked into
AC timing, don't know any method to fix that other than resetting the clock
on occasion
 
Top