R
racefan©
- Jan 1, 1970
- 0
Can anyone help with this DSC Power 832 problem? (PC5010 control panel)
Keypad is a LCD5501Z unit.
I powered up the system for the first time last night and was trying to
assign the keypad to a slot. I was able to enter the installer code
and get into programming but it was responding as expected so I
exited and was going to try again.
Now, the trouble light is on and I can't get the keypad to respond to any
input.
I tried powering the system off and on but the trouble lite stays on and
still no response.
*2 does not display any trouble conditions.
Thanks in advance,
jay
Keypad is a LCD5501Z unit.
I powered up the system for the first time last night and was trying to
assign the keypad to a slot. I was able to enter the installer code
and get into programming but it was responding as expected so I
exited and was going to try again.
Now, the trouble light is on and I can't get the keypad to respond to any
input.
I tried powering the system off and on but the trouble lite stays on and
still no response.
*2 does not display any trouble conditions.
Thanks in advance,
jay