T
TheM
- Jan 1, 1970
- 0
I've got a customer asking me for a 1000W RF VHF driver for their laser.
What are cutting lasers like as a load?
Are they resistive 50 ohms or complex?
Are there any spectral purity requirements or can you just drive them with
the RF from the PA with a bit of harmonics (say -20dbc for H2).
PS: I'll post solution to the flathead screw problem as soon as I get it
from my vendor so I can take some photos.
M
What are cutting lasers like as a load?
Are they resistive 50 ohms or complex?
Are there any spectral purity requirements or can you just drive them with
the RF from the PA with a bit of harmonics (say -20dbc for H2).
PS: I'll post solution to the flathead screw problem as soon as I get it
from my vendor so I can take some photos.
M