Maker Pro
Maker Pro

DP6150 shutting down

D

D Yuniskis

Jan 1, 1970
0
Hi,

I rescued a Proxima DP6150 that is in quite good
condition (cosmetically, low lamp hours, good image,
convergence, etc.).

But, it shuts down after just a few minutes of use.
At least one fan is running (I haven't looked inside
to see if there are multiple fans) -- though that
doesn't rule oout a probable (?) thermal issue.

Without any prints on this, I'm at a loss as to
where to begin... :< It may, in fact, be most
prudent just to salvage the bulb and send the
rest to Recycler Heaven.

Thanks!
--don
 
Top