Connect with us

Display problem with Tektronix TAS250 scope

Discussion in 'Troubleshooting and Repair' started by ghale3, May 1, 2011.

Scroll to continue with content
  1. ghale3

    ghale3

    1
    0
    May 1, 2011
    Perhaps someone can help me, or at least point me in the right direction to look. My scope has lost it's cursor readout. This is an overseas unit that Tektronix sold and I cannot find a schematic or much information on it at all. I am wondering if it is better to just replace it, though I have always liked it. Any help would be appreciated.
     
  2. davenn

    davenn Moderator

    13,555
    1,853
    Sep 5, 2009
  3. dskokic

    dskokic

    1
    0
    Sep 1, 2011

    I have the same problem with Tektronix TAS 250 oscilloscope. Cursor does not show up on the dispaly anymore. Can you help me to solve the problem ? Thanks!
     
  4. davenn

    davenn Moderator

    13,555
    1,853
    Sep 5, 2009
    Hi there
    welcome to the forums :)

    do as I suggested in my previous message and that you quoted :)
    there are many many subscribers to that yahoo group with lots of good info

    Dave
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-