Maker Pro
Maker Pro

disabled zone

It appears I did unhook the front door from the alarm system. The installer who fixed my inadvertant mistake didn't say how I did it, but he restored my dsc832 system back to normal. From the manuals I downloaded, I don't see what section controls this...
 
M

Me

Jan 1, 1970
0
It appears I did unhook the front door from the alarm system. The
installer who fixed my inadvertant mistake didn't say how I did it,
but he restored my dsc832 system back to normal. From the manuals I
downloaded, I don't see what section controls this...

if you dont need the zone, strap out the zone, with a 2.2k res at the
panel..The panel door, should have the scematics of the pin outs
 
F

fly in the ointment

Jan 1, 1970
0
Me wrote
if you dont need the zone, strap out the zone, with a 2.2k res at the
panel..The panel door, should have the scematics of the pin outs

I'm not sure that's what the OP is after, but if so, a 5.6K resistor is what
he'll need.
js
 
Top