Connect with us

DIN5 To DB15 (d-sub15) RS485

Discussion in 'General Electronics Discussion' started by tobbski, Sep 4, 2012.

  1. tobbski

    tobbski

    3
    0
    Sep 4, 2012
    Hello folks,

    I have been searching high and low on the net and.. no luck.

    I need to make a 15 pin D-Sub to 5 pin MIDI cable.
    I have a new midi cable. I went out and bought the required d-sub jack with casing.
    I have a soldering iron. And the guy at the electronic store told me that It can be done (with confidence).. it seems that I just need to find out which of the 5 midi wires connect to the particular d-sub pins.

    I patiently await your help-suggestions-and advice.

    Thanx
     
  2. Harald Kapp

    Harald Kapp Moderator Moderator

    9,131
    1,842
    Nov 17, 2011
  3. tobbski

    tobbski

    3
    0
    Sep 4, 2012
    Yes thanx, however i only need one of the DIN5 ports the "out" going port that is.
     
  4. Harald Kapp

    Harald Kapp Moderator Moderator

    9,131
    1,842
    Nov 17, 2011
    So you just leave out the "in" portion of the schematic. Where's the catch?
     
  5. tobbski

    tobbski

    3
    0
    Sep 4, 2012
    oki thanx dyast so i dont make a mistake.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-