Maker Pro
Maker Pro

Digital transistor for switching application

Akshatha Venkatesh

Jan 14, 2017
145
Joined
Jan 14, 2017
Messages
145
I found the below schematic in the application note of On semi. Can anyone please explain why two transistors are used , why is the npn transistor used to control the switching of the pnp transistor ? Why not use a single transistor ? Please help.
 

Attachments

  • IMG_20171123_155525.jpg
    IMG_20171123_155525.jpg
    72.8 KB · Views: 135

Harald Kapp

Moderator
Moderator
Nov 17, 2011
13,700
Joined
Nov 17, 2011
Messages
13,700
This is a high side switch (40 V) with integrated level shifter (control voltage ~5 V only).
You cannot control a switch on the 40 V rail (high side) directly from e.g. a microcontroller output pin (3.3 V or 5 V). The NPN transistor creates the base control signal for the PNP transistor while at the same time decoupling and protecting the microcontroller from the high voltage which would destroy the micorcontroller immediately.
 

Akshatha Venkatesh

Jan 14, 2017
145
Joined
Jan 14, 2017
Messages
145
Hi ,
This is a high side switch (40 V) with integrated level shifter (control voltage ~5 V only).
You cannot control a switch on the 40 V rail (high side) directly from e.g. a microcontroller output pin (3.3 V or 5 V). The NPN transistor creates the base control signal for the PNP transistor while at the same time decoupling and protecting the microcontroller from the high voltage which would destroy the micorcontroller immediately.
I have another question, when the output from microcontroller is high , the npn is on and pulls the base of the pnp to ground,which turns the pnp on, right ? And when the microcontroller output is low , the npn is off , which in turn the pnp off .is my understanding right ?
 

Akshatha Venkatesh

Jan 14, 2017
145
Joined
Jan 14, 2017
Messages
145
This is a high side switch (40 V) with integrated level shifter (control voltage ~5 V only).
You cannot control a switch on the 40 V rail (high side) directly from e.g. a microcontroller output pin (3.3 V or 5 V). The NPN transistor creates the base control signal for the PNP transistor while at the same time decoupling and protecting the microcontroller from the high voltage which would destroy the micorcontroller immediately.
Hi, why haven't used the NPN transistor as the switch ?
 

Alec_t

Jul 7, 2015
3,587
Joined
Jul 7, 2015
Messages
3,587
You could do that, but it would be more complicated because the NPN base would need an input (control) voltage 0.6V or so above the voltage you are trying to switch. That, in turn, would need a second supply.
 
Top