Connect with us

DCS 832 & LCD5501Z zones

Discussion in 'Security Alarms' started by Max, Nov 29, 2007.

Scroll to continue with content
  1. Max

    Max Guest

    This may be a dumb question but how do you program a zone off a
    keypad? The manual says to *8(installers code) 020 then zone numbers
    coresponding to the slot position of the keypad. When I do this the
    LCD5501Z displays attribut numbers but the additional zones will not
    program?? I am using 8 zones off of the panal and am trying to assign
    zone 9 ans 10 to two of the 4 keypads I have


    Thanks
     
  2. alarman

    alarman Guest

    You need to know the keypad address, 1 thru 8. Assuming your keypads are
    addressed 1 thru 4, and you want to program zone 9 on keypad 1, and zone 10
    on keypad 2:

    *8 <installer code> 020 09 10 ##
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-