Connect with us

Dataman Gang-of-Eight Eprom programmer software?

Discussion in 'General Electronics' started by Jerry, May 5, 2004.

  1. Jerry

    Jerry Guest

    I've acquired a Dataman Gang-of-Eight EPROM programmer with power
    supply but no software. It handles devices up to 27512 and voltages
    from 25v to 12.5v.

    So far so good, except I don't have any software :-(

    There's an RS232 port on the rear of the programmer which I've tried
    with terminal software but to no avail (though I might not have tried
    the correct commands). I've also tried the manufacturer but they no
    longer support the programmer.

    Anyone have any software to support this programmer?

    All advice and software gratefully received!

    Jerry
     
  2. Tony K

    Tony K Guest

    Why don't you try the company website???
     
  3. Jerry

    Jerry Guest

    Now why didn't I think of that?! Oh hold on, I *DID* think of that...

    Okay, reign in I'm teasing you *NOT* flaming you. I did visit the
    Dataman site but their support extends only to the current product
    line. They have a user forum and there are a couple of questions
    relating to the Gang-of-Eight eprom programmer, each of which poses
    the same questions as me, and none of which is resolved properly. Back
    to the drawing board…
     
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-