Maker Pro
Maker Pro

Data I/O 2900 Programmer

I recently had a problem with my programmer at my work place. I
installed the boot disk in the 3.5 disk drive and turned on the
programmer and I got a boot disk error. I tried a couple of more times,
same thing. I called Data I/O and they said the 3.5 floppy dirve was
bad. I found another 2900 on ebay. The programmer from ebay boots up
and works fine. However, I am using a much older revision boot disk. I
am looking for some one that would allow me to make a copy of a 2900
series, 6.50 revision or higher boot disk and algorithms. I have called
DataI/O and they do not support the 2900 or sell 3.5 floppies any more.
If there is someone out there that could help I would appreicate very
much.
 
Top