Connect with us

Cut off system with two momentary switches

Discussion in 'General Electronics Discussion' started by Youc15, Mar 10, 2014.

Scroll to continue with content
  1. Youc15

    Youc15

    1
    0
    Mar 10, 2014
    Hello all!

    I am in the middle of a project and I am a bit stuck in this portion of it :

    I have two momentary switches with one of them (call it s1) attached to a relay and on the other side of the relay a motor and battery. The operation I would want the motor to have would be this :
    When s1 is pressed and held down the motor spins. It spins until either s1 is released OR s2 is triggered but not held down. In order for the motor to spin again, s1 would have to be released and triggered again. So essentially, s2 would "cut off" power despite s1 being held down until s1 is pressed again.

    I know it could be done with relative ease with a microcontroller, but I want it to be as simple as possible.

    Thank you all in advance!
     
  2. Arouse1973

    Arouse1973 Adam

    5,164
    1,087
    Dec 18, 2013
    Something like this might work.
    Adam
     

    Attached Files:

Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-