Connect with us

Creating circuit onto a breadboard

Discussion in 'General Electronics Discussion' started by jlauj, Dec 3, 2016.

Scroll to continue with content
  1. jlauj


    Dec 3, 2016
    Hello, I am quite new to this whole electronics thing. I have a 3 wire pressure gauge, and I need to measure it output signal onto Labjack U3. I have a circuit schematic of how it should look, however I am quite lost on how to start with making it though breadboard.

    It is Figure 2 on this link.

    Also, the other question I have is do I have to use a shunt resistor for this?
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day