Maker Pro
Maker Pro

Counter interface?

G

George Francis

Jan 1, 1970
0
Hi All:

I have two freq. counters looking at slow switch closures ( switch
closures 1 to 3 sec. intervals) I need to know when either counter's
count exceeds the other by 5 counts and then sound an alarm (buzzer
??) When either counter reaches 25 counts an alarm will sound. I know
microcontroller will do this nicely, but I cannot, or do not have the
skills , to do this. Help will be most appreciated. GHF
 
W

Will

Jan 1, 1970
0
Hi All:

I have two freq. counters looking at slow switch closures ( switch
closures 1 to 3 sec. intervals) I need to know when either counter's
count exceeds the other by 5 counts and then sound an alarm (buzzer
??) When either counter reaches 25 counts an alarm will sound. I know
microcontroller will do this nicely, but I cannot, or do not have the
skills , to do this. Help will be most appreciated. GHF

Have you tried contacting the EE students at the local university, especially
the microcontroller savvy ones. They could probably help you out for much
cheaper than what you have to pay for a consultant.
 
G

George Francis

Jan 1, 1970
0
Have you tried contacting the EE students at the local university, especially
the microcontroller savvy ones. They could probably help you out for much
cheaper than what you have to pay for a consultant.

Will: Thanks, that;s a good idea....I do know the faculty, having
been part of it at one time. Regards. George
 
Top