Connect with us

Converting Eagle to Altium Designer

Discussion in 'CAD' started by OZ8HP - Hugo Pedersen, May 29, 2007.

Scroll to continue with content
  1. Is there any way to get an Eagle design converted to Altium Designer?

    Even if I will have to go via another program that will be acceptable.
  2. JeffM

    JeffM Guest

    The *Magical Tool* thing has been discussed before
    many times.*-nasty-cost+3rd-party-*+turf-battle

    If your tool can't deal with ASCII files at a *reasonable* level
    to get you the usual percentage of labor saved when translating,
    a temporary layer in the schematic capture tool (as well as in layout)
    would be a useful widget as a prompt to get you up again.
  3. What you say is: grab the current schematic in one hand and the mouse in the
    other and just get the work done?? :)
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day