Connect with us

Controlling a stepper motor

Discussion in 'Electronic Components' started by [email protected], Feb 7, 2005.

Scroll to continue with content
  1. Guest


    I have been given some stepper motors which were part of an old printer
    and scanner. I want to do a bit of experimentation with them and havent
    got the equipment to make my own controller so I did a search in on
    ebay and came up with these items number 3871692700, 3872498171 and
    3871716206. I measured my motorsand make the coils to be around 60 ohms
    on one motor and 230 ohms on one and 100 on one.

    has anyone had use of the controllers I looked at and could you
    possibly offer any advice on a good controller to use. I need something
    easy to use just to be able to make some simple moving model parts.

    Thankyou for your time

Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day