Connect with us

Connectors

Discussion in 'Electronic Design' started by Myauk, Feb 22, 2007.

Scroll to continue with content
  1. Myauk

    Myauk Guest

    One Consumer Electronics Product I tried to dismantle had many small
    Printed Circuit Board Modules and there had been set wiring connected
    by different types of connectors. (at least 10 types of connectors are
    found including FFC Connectors:-some are ZIF)
    There, I came to understand that for the electronics sets with
    complicated wiring between many modules, there should use connectors
    of different types in the designs to prevent the service personnel (or
    anyone who disassemble it) from reconnecting it wrongly while re-
    assembling it.
    Is there any article in a published book or any website have you seen
    described something concerning with using connectors while considering
    wiring between PCBoards in Designs (Guide lines, article or anything)?
    Or is there any comment from anybody?
     
  2. Rich Grise

    Rich Grise Guest

    The only real "guideline" I've ever used is: "Use what works".

    Cheers!
    Rich
     
  3. Myauk

    Myauk Guest

    :)
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-