Connect with us

Comunicate FPGA to Ethernet

Discussion in 'Electronic Design' started by Himlam8484, Mar 12, 2007.

Scroll to continue with content
  1. Himlam8484

    Himlam8484 Guest

    Hi people,

    In last my design, I made a fpga board using IC xc3s400. Now i would
    like to modify it some following things. I want to add a part into
    Fpga board. I want to use a chip W5100 to comunicated between FPGA
    board with ethernet.

    Do any one can give me some ideas? I hope that someone worked with
    this chip and got some experienced. please show me.

    i lloking forward hearing from people soon

    Him Lam
     
  2. Rich Grise

    Rich Grise Guest

    Well, you seem to already know how to work with the XC3S400 - there's a
    data sheet and stuff on the W5100 here:
    http://www.saelig.com/miva/merchant.mvc?Screen=PROD&Product_Code=ETH014&Category_Code=ETH

    It looks like a matter of connecting it to a port and learning how to
    control it, and writing a driver in the FPGA.

    Good Luck!
    Rich
     
  3. Himlam8484

    Himlam8484 Guest

    Hi Rich,

    Thank you for your supporting. I find many useful document from it. I
    also some new ideas for my design based on this chip.

    Lam
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-