Connect with us

Commiting a circuit to veroboard/stripboard

Discussion in 'General Electronics Discussion' started by Mark65, Oct 2, 2016.

Scroll to continue with content
  1. Mark65

    Mark65

    8
    1
    Aug 12, 2015
    Hello,
    I'm looking to make the attached circuit with veroboard/stripboard but wonderer if there is anything special about the location of the points VCC and IC1 point 8.
    They're almost at the same point in the circuit on a veroboard/stripboard with IC1 point 8 being between C13 and C7 and VCC being at the junction of C13.
    I've limited experience in electronics and was just wondering if it really makes a difference ?
    Thanks,
    Mark
     

    Attached Files:

  2. davenn

    davenn Moderator

    13,901
    1,971
    Sep 5, 2009
    hi Mark

    IC 1 and IC 2 are not likely and would not normally be mounted on the board right in the middle of the power supply
    one of the obvious reasons being, it would be difficult route other connections to the other pins of those 2 IC's
    Those IC's are likely to me mounted further down on that board or, more likely, on a totally different board all together

    this is going to be the reality ......

    upload_2016-10-2_19-17-31.png





    Dave
     
    Last edited: Oct 2, 2016
  3. Mark65

    Mark65

    8
    1
    Aug 12, 2015
    Dave, Thanks
     
    davenn likes this.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-