Connect with us

CNC driver help

Discussion in 'Project Construction Technologies' started by Dude22, Nov 29, 2012.

Scroll to continue with content
  1. Dude22


    Mar 30, 2012

    I recently had a thread where I asked for help deciding on a 3 axis CNC driver and eventually decided on the following driver:

    It works GREAT only 1 axis does not work... The Y axis. I am talking to the company and am hopefully getting a new driver. The only problem is that could take months and shipping last time took 4 weeks!!! In the mean time I am looking at getting a 1 axis driver for temporary use. The board has a 4th axis expansion port with 5 outputs: 5v, CK, CW, EN and GND Will these outputs work with this board:

    I am on a tight time line so any help would be GREATLY appreciated.

    Last edited: Nov 30, 2012
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day