Connect with us

Class D (switch mode) unipolar mosfet audio amps

Discussion in 'Electronic Repair' started by N Cook, Jun 3, 2007.

Scroll to continue with content
  1. N Cook

    N Cook Guest

    That is using non complementary pairs of N-channel,only, mosfets.
    Can anyone direct me to a useful primer for such designs , with "bias" to
    repair considerations, eg powering up suspect/half repaired such amps with
    reduced power rail levels - what effects to expect or even if its possible ?
    both-on possibilities etc
     
  2. Guest

    Well, other than mosfets usually go short circuit when they fail, no
    mate!
     
  3. N Cook

    N Cook Guest

    For a stereo pair of class D switching amps, +&-rails driven from 2 switch
    mode power supplies, one - , one+, would they all be tied to the same
    frequency, to avoid beats?
    Anyone know if thats the case?
     
  4. Guest

    would such beats become audible?


    NT
     
  5. N Cook

    N Cook Guest

    I can find plenty on design of such amps but not the practical implications
    , let alone repair of such amps. If one was at 50KHz and the other 51KHz or
    so, or one 50KHz and the other 251KHz or so , at high power levels, could
    there be some annoying beat effect ? either from the internal
    wiring/transformers or in the output audio
     
  6. Marra

    Marra Guest

    Usually MOSFETS go, test and replace them as necasary.

    After that I would send the amp to an expert engineer before you blow
    yourself up !
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-