Connect with us

Circuit Help Needed

Discussion in 'Project Construction Technologies' started by Machine Doctor 13, Jul 25, 2019.

  1. Machine Doctor 13

    Machine Doctor 13

    7
    0
    Jul 13, 2019
    I have constructed the attached circuit on a breadboard and it works. The clock pulse to the 4022 is a + 15 VDC signal, and the outputs from the 4022 are also + 15V. The outputs from the 2981A are + 15V too, but I need to convert them to + 24V for the CNC control board inputs.

    Any ideas would be greatly appreciated.
     

    Attached Files:

  2. Harald Kapp

    Harald Kapp Moderator Moderator

    9,226
    1,860
    Nov 17, 2011
    Use the UDN2981A Driver with 24 operating volatge instead of the 15 V currently used.
     
  3. Machine Doctor 13

    Machine Doctor 13

    7
    0
    Jul 13, 2019
    Thanks much!
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
There are no similar threads yet.
Loading...
Electronics Point Logo
Continue to site
Quote of the day

-