Maker Pro
Maker Pro

Caller ID info needed

  • Thread starter Rudolf Ladyzhenskii
  • Start date
R

Rudolf Ladyzhenskii

Jan 1, 1970
0
Hi, all

Can anyone point me to a good source information about caller ID in
Australia. I am after technical details.

Thanks,
Rudolf
 
I

Iain Chalmers

Jan 1, 1970
0
Rudolf Ladyzhenskii said:
Hi, all

Can anyone point me to a good source information about caller ID in
Australia. I am after technical details.

This is neither a "good source", or "in Australia", but it may give you
a few useful hints...

http://www.jwz.org/cid/

big
 
R

Rod Speed

Jan 1, 1970
0
Can anyone point me to a good source information
about caller ID in Australia. I am after technical details.

Its close enough to what is used in north america for practical purposes.

The only real difference is where it appears in the ring cadence
since our ring cadence is different to what is seen in north america.

Close enough so that yankee modem caller id works fine here.
 
R

Rudolf Ladyzhenskii

Jan 1, 1970
0
Thanks,

I'll look at US stuff.

Pity, Motorola used to make CID decoder IC. Not anymore.

Rudolf
 
Top