Connect with us

bus hold driver

Discussion in 'Electronic Basics' started by steve, Oct 26, 2004.

Scroll to continue with content
  1. steve

    steve Guest

    Hello,

    I'm very new to the concept of bus hold.

    My question:

    If I want to have a logic low on one of the bus lines, does it matter
    whether I put the pull-down resistor on the output or the input? I'll
    be using a SN74LVCH244A in my design? Also, can I assume the state of
    the any SN74LVCH244A output (without pull-downs/pull-ups) on power-up
    is logic low.

    Thanks,
    Steve
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-