Maker Pro
Maker Pro

Burleigh PZ-70

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
Does anyone have any information on these?

I have a sick one.
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
Aha! Mine is actually in perfect working order!

My fault was that I didn't wait long enough for the tube to warm up.

What symptoms does yours have?

Can you see the tube's filament glowing?

Do you have the clear back cover in place?

Do you have the various links in place on the rear connectors? (I think there should be 5 of them)
 

Mudflap

Sep 13, 2016
3
Joined
Sep 13, 2016
Messages
3
Aha! Mine is actually in perfect working order!

My fault was that I didn't wait long enough for the tube to warm up.

What symptoms does yours have?

Can you see the tube's filament glowing?

Do you have the clear back cover in place?

Do you have the various links in place on the rear connectors? (I think there should be 5 of them)
 

Mudflap

Sep 13, 2016
3
Joined
Sep 13, 2016
Messages
3
I must have a different model because mine does not have any tubes.
I have a solid state version Burleigh PZ-70 High Voltage DC Op Amp.
Mine has 2 of 4 high wattage resistors that burned and I can't make out
their values and I can't seem to find any schematics.
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
Hi @Mudflap, I just realised that I confused two pieces of equipment in this thread.

The device with the tube is an APH-1000 high voltage power supply.

My Burleigh PZ-70 seems to work fine.

If you're still around, I have attached a photo of mine. Tell me which resistors you're talking about and I'll compare it to mine.

IMG_20171209_134647.jpg

The two brown resistors near the top right are 50k 20W.
 
Top