Connect with us

Brushless DC Motor Driver Help

Discussion in 'Sensors and Actuators' started by Ramazan Kendirci, Dec 20, 2016.

Scroll to continue with content
  1. Ramazan Kendirci

    Ramazan Kendirci

    1
    0
    Dec 20, 2016
    Hello, I built this circuit on Proteus to drive a brushless dc motor by using 555 timers in monostable mode I know this is not a efficient way but i am just trying. this actually works by using variable resistors in place of R1 R2 and R3 chancing resistance changes pulse duration but driving with 3 resistor is not a practical way so i wonder if i could make it voltage controlled in single point or is this circuit just a trash which gives noting ? is it works if i just change the power voltage in a specified interval ? Please give me your comments on circuit and please help me. Thank you.
    dc_driver.jpg
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-