Connect with us

Broken charger component on circuit board of my Bluetooth speaker

Discussion in 'Troubleshooting and Repair' started by Acd.demarest, Jan 7, 2018.

Scroll to continue with content
  1. Acd.demarest

    Acd.demarest

    2
    0
    Jan 7, 2018
    I need help fixing the charger plug-in component on the PCB of my Bluetooth speaker!!

    My main question would be that could it be possible to just solder a wire to neg and a wire to pos of the PCB board where the charger plug-in gets soldered at?

    And if doing so will it charge properly?
     
  2. Harald Kapp

    Harald Kapp Moderator Moderator

    11,513
    2,651
    Nov 17, 2011
    Probably. How about a photo of the part that's affected?
     
  3. Acd.demarest

    Acd.demarest

    2
    0
    Jan 7, 2018
    Ok I can send a photo here shortly. But to be a quick fix simple and free I just want to solder wires to the board where the micro usb is supposed to be soldered to
     
  4. Harald Kapp

    Harald Kapp Moderator Moderator

    11,513
    2,651
    Nov 17, 2011
    That should work.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-