Maker Pro
Maker Pro

Brightness Control of Monitor

C

Christopher

Jan 1, 1970
0
Hello,

Since the day I received my Gateway Vivitron or CS1572 8 years ago it
has had dim brightness (no detail in dark areas of photos). The normal
controls on the front of the monitor are maxed out.

Today I pulled the monitor cover and found two focus controls on
the left side.

There is a third Pot under the two focus controls that is "glued" into
a fixed position,


would this be the brightness control?


Thank you for your kind feedback,

* * *
Christopher

Temecula CA.USA
http://www.oldtemecula.com
 
S

Sam Goldwasser

Jan 1, 1970
0
Christopher said:
Hello,

Since the day I received my Gateway Vivitron or CS1572 8 years ago it
has had dim brightness (no detail in dark areas of photos). The normal
controls on the front of the monitor are maxed out.

Today I pulled the monitor cover and found two focus controls on
the left side.

There is a third Pot under the two focus controls that is "glued" into
a fixed position,

It is probably the screen/G2 control and will affect brightness.

However, there may be another master brightness control somewhere, or
it may be a menu item only accessible via special software.

It shouldn't hurt to turn up the screen/G2 pot slightly. That may be all
you need.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
 
Top