Maker Pro
Maker Pro

Blue flash

N

N_Cook

Jan 1, 1970
0
A friend of a friend asked me about some mixer-amp, make unknown.
It works fine but every now and they see a blue flash through vent holes.
Presumably before the reservoir caps and a break at mains volts, but what?
A green flash from a seriously overloaded fuse rupturing, but that would be
one-off, but what could give a blue flash ?
 
S

Sam Goldwasser

Jan 1, 1970
0
N_Cook said:
A friend of a friend asked me about some mixer-amp, make unknown.
It works fine but every now and they see a blue flash through vent holes.
Presumably before the reservoir caps and a break at mains volts, but what?
A green flash from a seriously overloaded fuse rupturing, but that would be
one-off, but what could give a blue flash ?

Bad connection, arc-over, family of ants walking across the line. :)

Sorry, this is the sort of thing you'll have to check out for yourself!

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
 
A

Arfa Daily

Jan 1, 1970
0
N_Cook said:
A friend of a friend asked me about some mixer-amp, make unknown.
It works fine but every now and they see a blue flash through vent holes.
Presumably before the reservoir caps and a break at mains volts, but what?
A green flash from a seriously overloaded fuse rupturing, but that would
be
one-off, but what could give a blue flash ?

At this point, that's a bit like saying "I have a friend that has some kind
of vehicle with some wheels on, and sometimes it rattles. Anyone got any
thoughts on what it might be ?"

Do we even know if it is valve or semiconductor ? Valve flashovers can give
a pretty good blue flash without too much interuption to operation. I would
have thought that any flashover big enough to be seen on a semiconductor
amp, even at the mains end of things, would be associated with other
(audible) problems ...

Arfa
 
P

pipedown

Jan 1, 1970
0
N_Cook said:
A friend of a friend asked me about some mixer-amp, make unknown.
It works fine but every now and they see a blue flash through vent holes.
Presumably before the reservoir caps and a break at mains volts, but what?
A green flash from a seriously overloaded fuse rupturing, but that would
be
one-off, but what could give a blue flash ?

The color of an ARC is generally unimportant. The voltage of the arc, the
gas mixture near the arc and any contamination and the total charge
transfreerd all play a part in the color. Yellow to blue white is normal,
green indicates vaporized metal or other contaminant, red is fire or hot
wire not an arc typically.

What is important would be where the arc occurs. Usually once arcing starts
occuring, a component has critically failed. There are very few non
destructive failure modes that involve arcing.

Do you smell anything when it flashes. Acrid smoke or just ozone?
 
Top