Connect with us

Black lines across tv screen

Discussion in 'Electronic Repair' started by bones, Mar 2, 2005.

Scroll to continue with content
  1. bones

    bones Guest

    I have an older JVC 27" television. Sometimes it has horizontal black lines
    that go directly across the botton and middle of the set. They come and
    they go but when they do come you can give the side of the set a good whack
    and they go away, only to come back again later. Any idea why this occurs?

    Thanks in advance
     
  2. sofie

    sofie Guest

    bones:
    The black lines occur most likely because of "cold", cracked, or otherwise
    faulty solder connections. Of course there could be other faults that
    could cause this.
    My advice to you is to STOP whacking the side of the television set.....
    this problem will only get worse, it will not heal itself, and it will
    probably get worse to the point that you can not make the problem go away or
    the picture will collapse completely.....
    ......then the repair will be much more involved and more expensive than
    fixing just the bad solder connections.
    STOP using this television and get it to a service shop for a proper repair
    or at the very least a repair cost estimate so you can make an intelligent
    repair decision with facts instead of internet or telephone wild guesses.
    Most likely this will not be a very expensive repair unless you continure to
    "nurse" this along and delay getting the proper repair done.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-