Connect with us

black & decker

Discussion in 'Electronic Basics' started by lurk, Dec 17, 2004.

Scroll to continue with content
  1. lurk

    lurk Guest

    anyone have a power supply for a b&d cordless drill the model
    number of the power supply is PS-180
    I would like to know the resistor values of the 2 resistors in
    the unite.....it is ac charger for a 14 v battery pack.....

    any help....thanks
     
  2. Mike

    Mike Guest

    I'd help you out, but I have a PS160 charger for a B&D 12V drill. If you
    have open/shorted resistors, you probably have something else wrong with the
    unit that caused those components to fail.

    Cheers,
    Mike
     
  3. lurk

    lurk Guest

    thanks...there isn't that much to it a full wave bridge and 2
    resistors and 1 L.E.D...the original wall wart was open on the
    primary and I replaced that but then it smoked the resistor...
    any suggestions
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-