Connect with us

bent iPod sync port

Discussion in 'Electronic Repair' started by Mick, Jul 24, 2007.

Scroll to continue with content
  1. Mick

    Mick Guest

    The edge of the sync/charge port on my 30gb iPod video is bent and I
    can't hook it up to the charger any longer without damaging
    something. Since otherwise the iPod is perfectly OK, but Apple won't
    touch it, I wanted to replace the bent port. Does anyone know if I
    need to replace the whole circuit board assembly or if it is a stand
    alone part? It doesn't seem like a huge big deal, but any advice
    anyone has would be gratefully accepted.
  2. Guest

    If you want to sell it check out this ad "sell your Ipod for cash"...
    in the left frame at
  3. DaveC

    DaveC Guest

    It doesn't seem like a huge big deal, but any advice
    Check out < broken> for an
    identical model with broken display. Or post your own ad for such. Buy for
    parts and exchange the entire PCB that has the connector.

    If I were you, I wouldn't want to un/solder that connector on the PCB...

    Good luck,
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day