Maker Pro
Maker Pro

Auto garage door opener

btwizzle

May 12, 2013
1
Joined
May 12, 2013
Messages
1
Hi there,

My automatic garage door needs a push button (open/close) and indicator light inside the house so I can open/close the door from inside.
Also would be good to have the the inside indicator light go on/off when I use the garage door remote to open/close.
Any help would be much appreciated

Cheers
 

Stuart

Jan 24, 2013
23
Joined
Jan 24, 2013
Messages
23
Your question is quite vauge.
What are you asking for exactly?

Are you trying to design your own garage door opening/closing system and you're needing help on where to start?

Are you looking for someone to design something for you?

Or do you want someone to point you in the right direction in terms of existing products?

Stu.
 

CDRIVE

Hauling 10' pipe on a Trek Shift3
May 8, 2012
4,960
Joined
May 8, 2012
Messages
4,960
I'm going to assume that your existing pushbutton switches are momentary. In this case you're inside panel will have the up & down switches wired in parallel with its corresponding garage switch.

Be aware that what your doing is dangerous! It would probably void the liability section in your insurance policy. Opening and closing a garage door that you can't see is not wise.

Chris
 
Top