Maker Pro
Maker Pro

AUTO blinking light on JVC VCR

M

Mark

Jan 1, 1970
0
Hi. I've had a blinking AUTO in the front window, and it wouldn't load a
tape. I replaced the mode switch, and it loads fine. However it won't go
into play mode, nor will it rewind,FF or eject and I still have the blinking
AUTO in the the window. Any ideas? Thanks. Mark.
 
L

lsmartino

Jan 1, 1970
0
Mark ha escrito:
Hi. I've had a blinking AUTO in the front window, and it wouldn't load a
tape. I replaced the mode switch, and it loads fine. However it won't go
into play mode, nor will it rewind,FF or eject and I still have the blinking
AUTO in the the window. Any ideas? Thanks. Mark.

Is, by chance, the recording timer accidentally set?
 
J

JR North

Jan 1, 1970
0
Perhaps auto channel preset function, with tuner fault or no IN cable
signal...
JR
 
M

Mark

Jan 1, 1970
0
No the auto recorder is not set. I've unplugged several times but I still
have the same problem, it's locked up and the Auto light keeps blinking.
 
R

Ray L. Volts

Jan 1, 1970
0
Mark said:
Hi. I've had a blinking AUTO in the front window, and it wouldn't load a
tape. I replaced the mode switch, and it loads fine. However it won't go
into play mode, nor will it rewind,FF or eject and I still have the
blinking
AUTO in the the window. Any ideas? Thanks. Mark.

Checked voltages on the servo controller IC?
 
Mark:
Take your factory remote & hold the power button
down on it for 6 to 10 seconds (aim it at the VCR) ,
it should then power up and work properly.
electricitym
.. . . . . .
 
M

Mark

Jan 1, 1970
0
I will give them both a try and let you know, thanks.
 
Top