ardino code for Two color LED to PIC18F45K80

bertus · Oct 11, 2020

Hello,

Then the green is probably blown.

What happens when you connect the left pin to + 5 Volts via the resistor and the right pin to ground?

Bertus

Djsarkar · Oct 11, 2020

bertus said:

Hello,

Then the green is probably blown.

What happens when you connect the left pin to + 5 Volts via the resistor and the right pin to ground?

Bertus
Click to expand...

Previously red was turning on, now it is not turning on. It is very sad to inform that both the leds has been damaged.
Bertus thanks for helping me

bertus · Oct 11, 2020

Hello,

Where did you buy the module?
Perhaps you can buy some bi-color 3 pin led and replace it.

Bertus

hexreader · Oct 11, 2020

Hard to be sure, but from your earlier picture, it looks as though you are using a 1000 Ohm resistor and a 56 Ohm resistor

1000 Ohms = good
56 Ohms = burnt out LED

Djsarkar · Oct 11, 2020

bertus said:

Hello,

Where did you buy the module?
Perhaps you can buy some bi-color 3 pin led and replace it.

Bertus
Click to expand...

I bought a 37 into 1 sensor kit from aliexpress long time back. I did not find any document user manual. Sure I will replace Led.
I have other sensor, they still have to be tested. I will test any one of them

bertus · Oct 12, 2020

Hello,

When you bought the 37 in 1 kit, have a look here:
https://tkkrlab.nl/wiki/Arduino_37_sensors
They tested the modules on either arduino or Raspberry pi.

Bertus

ardino code for Two color LED to PIC18F45K80

bertus Moderator

Djsarkar

bertus Moderator

hexreader

Djsarkar

bertus Moderator

Temperature sensor with PIC18F45K80

Thermocouple Interfacing with PIC18F45K80

LED blinking assembly code

Code needed for PIC16F684 to control LED's

help to optimize code!!

Code light to pulse

how to write c code for motor

Looking for a 1.5" color LCD!