Anyone in Melb doing low-cost short run PCB'S????

[User]

G'day!

Looking for somewhere in melbourne to get a short run of pcb's done (around
20 small boards)

Single sided 0.8mm and less that 50 holes per board......

Any ideas??

CHEERS!

 

[Rudolf Ladyzhenskii]

www.futurlec.com

Rudolf

 

[Richard Freeman]

G'day!

Looking for somewhere in melbourne to get a short run of pcb's done (around
20 small boards)

Single sided 0.8mm and less that 50 holes per board......

Any ideas??

Printed Electronics.....
Mike Lynch (03) 9545 3722, at email [email protected]
Does Beautiful PCBs .....

 

[budgie]

www.futurlec.com

I don't think their proto service is anything but 1.6mm.

Just received another proto batch from them - at their NEW 2004 PRICES (big
jump) - and sent them back staright away. Quality has gone out the window since
the Sep-03 batch I received. I'm waiting for comment from them on my email or
on the returns, but so far nothing.

In the past I have been known to recommend them. Right now, this here jury is
out.

 

[Mark van der Eynden]

G'day!

Looking for somewhere in melbourne to get a short run of pcb's done (around
20 small boards)

Single sided 0.8mm and less that 50 holes per board......

Any ideas??

CHEERS!

Printed Electronics
12A Aristoc Rd.
Glen Waverley
PH: 1300 132 251

 

[User]

Thanks guys!

Gives me some people to chase up.....

CHEERS!

 

[Rudolf Ladyzhenskii]

I got some boards abouit two weeks ago -- no problems on PCB.
Prices are still OK too, especially with strong Aussie dollar.
Rudolf

 

[budgie]

I got some boards abouit two weeks ago -- no problems on PCB.

So we need to work out whether your batch or mine was the aberration. Mine are
currently back in Thailand. Will report on ANY feedback I get.

Prices are still OK too, especially with strong Aussie dollar.

Not bad, but what was 3c in Sept is now 7c per sq.