Connect with us

anyone have experience repairing WaveTek 288 signal generators?

Discussion in 'Troubleshooting and Repair' started by slburris, Jun 19, 2010.

  1. slburris

    slburris

    1
    0
    Jun 19, 2010
    When I run the internal calibration routine on my WaveTek 288
    signal generator, I get the error: ERR OFSTGAIN

    The documentation simply says check motherboard, phase board,
    and output board, which doesn't narrow it down a whole lot!

    It would be nice to know what calibration is touching during the event
    that causes the offset gain error, but that's not described in the manual.

    Bessides the general advice to "replace all the capacitors", anyone
    seen this and fixed it?

    Scott
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-