Connect with us

Anybody knows the version in smd from this connector?

Discussion in 'Datasheets, Manuals and Component Identification' started by williambartko, Aug 7, 2014.

Scroll to continue with content
  1. williambartko

    williambartko

    2
    0
    Aug 7, 2014
  2. OLIVE2222

    OLIVE2222

    690
    25
    Oct 2, 2011
    They don't look to exist in SMD version, you can maybe use pin in paste method.
     
  3. williambartko

    williambartko

    2
    0
    Aug 7, 2014
    Thanks!
     
  4. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,480
    2,828
    Jan 21, 2010
    I agree. Another alternative is to bend the pins at right angles (the same way surface mount pins are bent) and solder them to the board.

    The reason these are probably not available as surface mount is that the load placed on the connector is perhaps best transmitted to the board rather than to the glue holding the copper to the board.
     
    shady likes this.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-