Hi
I have a start-up problem with my TDS3014B. It start backlight and actually the start screen is Ok. It pulses all front leds for a little bit and then the 1KHz/5V square wave becomes available. Start screen remains without change and there is no any diagnostic message. Troubleshooting chart doesn't cover this situation since it only is useful when diagnostic message apply. It seems to be a software problem rather than electronic problem.
Service from Tek is expensive. I heard about a key sequence to initiate to factory settings.
I will aprreciate if somebody have an idea to solve this...
Regards
John_H
I have a start-up problem with my TDS3014B. It start backlight and actually the start screen is Ok. It pulses all front leds for a little bit and then the 1KHz/5V square wave becomes available. Start screen remains without change and there is no any diagnostic message. Troubleshooting chart doesn't cover this situation since it only is useful when diagnostic message apply. It seems to be a software problem rather than electronic problem.
Service from Tek is expensive. I heard about a key sequence to initiate to factory settings.
I will aprreciate if somebody have an idea to solve this...
Regards
John_H
