N
Nick
- Jan 1, 1970
- 0
Hi,
I want to reduce a circuit for sensing current (Hall Sensor used). In
this circuit i measure current from two different motors on a single
board. The current is sensed and fed to the Signal conditioning circuit
which again combines both motor signals and generate fault signal. Is
it possible to do so? Can i use a multiplexer to do the same? I have
never used one..
Thanks and regards.
Nick
I want to reduce a circuit for sensing current (Hall Sensor used). In
this circuit i measure current from two different motors on a single
board. The current is sensed and fed to the Signal conditioning circuit
which again combines both motor signals and generate fault signal. Is
it possible to do so? Can i use a multiplexer to do the same? I have
never used one..
Thanks and regards.
Nick